Sony SU-WL100 Mode D'emploi page 6

Step 2:
Adjusting the position
of the holders of the
Base Plate
1
TV screen size
26 inch
20 inch
Other
1 Remove the screws that secure the left and right
holders to the Base Plate and move the holders to
the inner position.
2 Firmly secure each holder using the screws
removed in the previous procedure 1.
Notes
• When using an electric screwdriver, set the torque setting
to approximately 1.5 N·m {15 kgf·cm}.
• Make sure that the four screws that secure the Base Plate
and the holders are securely tightened.
6
(GB)
Procedure
This procedure is not necessary.
Follow this procedure.
Refer to the leaflet supplied
with your TV.
Holder
Step 3:
Deciding on the
installation location
1
Referring to the TV installation
dimensions table on page 12,
decide on the installation location.
Allow for suitable clearance between the TV and the
ceiling and protruding parts of the wall as shown
below.
Unit: mm (inches)
100
(4)
Never install the TV set as shown below:
Air circulation is
blocked.
Note
If you intend to route the cables in the wall, make a
hole in the wall to insert the cables before beginning
the installation.
100
(4)
Wall