Important Information For Your Safety; Intended Use; Safety Information For The Installer - Harvia Sentio QUBE-090 Instructions D'installation Et Mode D'emploi

Instructions for installation and use

2. Important information for your safety

The Qube sauna heater has been produced in accordance with the
applicable safety rules and regulations. However, hazards may oc-
cur during use. Therefore adhere to the following safety information
and the specific warning notices in the individual chapters.

2.1. Intended use

The Qube sauna heater is intended solely for heating sauna cab-
ins, in conjunction with a sauna control unit which does not include
a remote start function.
The Qube sauna heater can also be operated using a sauna control
unit with a remote start function, but only in conjunction with the
optional cut-off rocker switch (HT-SWL).
The Qube sauna heater can also be used in public saunas, but
only in conjunction with the optional cut-off rocker switch (HT-SWL).
Any use exceeding this scope is considered improper use. Improper
use can result in damage to the product, severe injuries or death.

2.2. Safety information for the installer

● Installing and connecting the sauna heater may only be performed
when the power supply is disconnected.
● Installation may only be performed by a qualified electrician or
similarly qualified person.
● A fully disconnecting all-pole isolating device compliant with
overvoltage category III must be fitted on site.
● Always use silicone cables that are heat-resistant up to 150 °C
to connect the sauna heater.
p. 5/28
EN