3.1 Installation And Adjustment; Manner Of Delivery - Vermeiren 708D Mode D'emploi

5. A steeper (greater) angle within the preferred zone is desirable.
6. Adjust the belt tightly according to the instructions of the strap-system manufacturer,
consistent with the user's comfort.
7. Ensure that the restraint belt connects in a straight line to the anchor point in the
vehicle and that no bends in the belt are visible, for instance at the axle of the rear
wheel.
8. Install the arm rests, if desired. make sure that belts are not twisted or held away
from the body by wheelchair components such as arm rests or wheels.
3 Installation and adjustment
The instructions in this chapter are for the specialist dealer.
The Vermeiren wheelchairs 708D has been designed entirely for your comfort.
To find a service facility or specialist dealer near you, contact the nearest Vermeiren facility.
A list of Vermeiren facilities can be found on the last page.
WARNING:
L Risk of unsafe settings - Use only the settings described in this
manual.
WARNING:
L Variation of allowed adjustments can still change the stability of your
wheelchair (tilt back or sideways).
3.1 Tools
To set up the wheelchair the following tools are needed.
Wrench set n° 10 to n° 19
Allen key set n° 4 to n° 5
Screwdriver Phillips head
3.2

Manner of delivery

The Vermeiren 708D shall be delivered with:
1 frame with arm supports, rear and front wheels (seat height of 500 mm - 19.69 in.,
seat angle of 5°)
1 pair footrests
Back and seat cushions
Tools
Manual
Accessories (optional)
Pump (with pneumatic tyres only)
Page 14
708D
2011-05