LaserLiner Titanium Mode D'emploi page 22

Titanium
Laser modes
The following modes can be controlled with the Commander 50 up
to a maximum distance of 50 m. Open battery compartment and
insert battery according to picture on the right, ensure polarity is
correct and close battery compartment. The rotating laser can also
be controlled with the SensoCommander.
Point mode
To establish point mode, press button (16) repeatedly until
the laser no longer rotates. The laser can then be precisely
positioned to the measuring level with the direction
buttons (15).
Rotary mode
Use button (16) to set the desired speed of rotation: 0, 150, 500 rpm.
Scan mode
Button (17) can be used to activate and set an intensive light segment
with one of 4 different widths. The segment can be positioned with the
direction buttons (15).
Hand receiver mode
Working with the optional laser receiver: Switch on
the SensoLite laser receiver with the botton (18).
With the Commander 50 and SensoCommander you
could set the maximum rotary speed, 500 rpm. It is
able to detect the laser beam at a great distance
now. Move the SensoLite up and down through the
laser beam until the middle indicator (24) appears.
Mark the measured height at the perimeter marking
groove.
SpotLite Marking: The projected light beam at the
height of the laser beam simplifies precise marking
and prevents parallax error.
22 ENGLISH