LaserLiner Titanium Mode D'emploi page 16

Titanium
Sensor Automatic
The Titanium is of the self-levelling kind. After it has been put in the required
basic position, fine adjustment is being effected automatically. Horizontal and
vertical orthogonal adjustments are effected by the self-levelling system (SLS),
while the X-, Y- and the Y-axis are scanned by two electronic measuring sen-
sors. The working angle is ± 5°.
Anti-Drift-System (ADS)
The Anti-drift system (ADS) prevents mismeasurements. Its principle of func-
tion: 10 seconds after ADS has been activated, the laser is permanently being
checked for its correct adjustment. In case the instrument has been moved by
external influences or the laser has lost its frequency, the system switches
itself automatically off and the "tilt"-LED shows a permanent light. After the
instrument has been switched on, the ADS is not active. In order to protect
the instrument from position changes caused by external influences, the ADS
has to be activated by pressing the push-button "tilt"(J). Should the instru-
ment be moved by external influences, then the laser is switched off and the
"tilt"-LED (K) shows a permanent light. The instrument has to be switched
off and -on again if work is to be commenced. This is a simple and reliable
prevention of misreadings.
Attention: The ADS-function will switch on the control of the laser 10 sec.
after the laser has completely been levelled (adjustment phase). Tilt display
(K) emits long blink signals during the adjustment phase and short blink
signals when ADS is activated.
ADS-function:
ON
Adjustment phase
Sensor Automatic
16
after 10 sec.,
short blink signals
Rotation
in tilt display (K).
begins
Acticate ADS:
Press "tilt" but-
ton (D), long
blink signals in
tilt display (K).
ENGLISH
The laser switches
itself off for safety
reasons, the "tilt"-
LED shows a ON
permanent light.
External
influence