LaserLiner Titanium Mode D'emploi page 19

Key pads and symbols LCD-Display
Commader 50
16
17
18
19
14 Speed / Angle range / Adjusting
axis at auto/man mode /
Volume at Hand receiver mode
15 Position
16 Rotations-Modus
17 Scan mode
18 Hand receiver mode
19 Calibration mode:
Switch X-, Y,-axis
20 Calibration mode: Adjusting axis
21 Calibration mode: Saving the new
calibration.
Note:
The laser receiver has two tolerance settings: Precision and free-hand setting.
On the SensoCommander 120, the settings are indicated by LEDs: precision set-
ting: green; free-hand setting: orange.
SensoCommander
15
14
21
20
22 Display measuring range selection
23 Hand receiver above laser level
24 Precisely on laser level
25 Hand receiver below laser level
26 Acoustic signal display
27 Low battery display
28 Hand receiver mode /
ENGLISH
22
23
24
25
26
27
28
14
(Volume only)
Switch: Precision range
Free-hand range
Titanium
SensoLite
19