LaserLiner Titanium Mode D'emploi page 21

Horizontal and vertical use
Setting up:
• Horizontal: Position the device on a level surface or on a tripod.
• Vertical - fix vertical holder (M), unfold centric point (O) and position unit in
vertical mode. Pre-adjust unit with vertical vial (R) and adjusting screws (N).
The sensor then adjusts the unit automatically. For use on tripods remove
vertical holder (M) and screw-on tripod holder (L).
• PRESS THE "ON/OFF" SWITCH (G).
• The device automatically levels itself within a range of ± 5°. When levelling
has been completed, the laser rotates at maximum speed. The operating
display (I) is lit up and the rotary laser is in the hand receiver mode. Switch
on the laser receiver with the button (18), the button (18) and the laser
beam is recognised.
Note: If the device is too far off the horizontal (more than 5°), a warning signal
will sound and the rotor head will stop. In this case, the device must be
repositioned on a more level surface.
Turn the vertical plane:
• In vertical use the laser plane can exactly be turned. Press auto/man
button (F).
• The vertical plane (+ 5°) can now be changed with the Commander 50 or
SensoCommander. To do this press buttons (14)
Manual Slope function:
• The Sensor-Automatic adjusts the X and Y axes. However, if it
is intended to project an incline, Sensor-Automatic must be
switched off.
• To project an aincline, press the auto/man (F) button. The X
axis can now be adjusted, and the X axis display (H) lights up.
To adjust the inclination of the Y axis, press the tilt button (J);
the Y axis display (H) lights up.
• Adjustment of the X and Y axes is done using the Commander 50 or
SensoCommander. To do this, press buttons (15).
ENGLISH
Titanium
In 1 plane
In 2 planes
21