Operation - Dexter 150MD2.5 Mentions Légales & Consignes De Sécurité

5. BEFORE PUTTING THE EQUIPMENT INTO
NOTE : instruction that the maximum recommended diameter of mounted wheels,
threaded cones and plugs shall not exceed 5mm and that the maximum recommended
diameter of sanding accessories shall not exceed mm.
WARNING : do not touch the tip of the accessory after use, it will be very hot and
may hurt your hand.
NOTE : The length range of accessories's metal pole is 20-50mm.
When the metal pole is completely insert into collet ,the maximum allowable overhang length of the metal pole is 25 mm.
Installing flex shaft
A flexible shaft can be connected to the rotary tool for working in hard to reach areas and for better control during delicate work.
Press the spindle lock button and loosen collet nut by spanner.
Insert drive shaft into collet nut and tighten the collet nut completelyn
Insert cup end of flex shaft onto rotary tool head and tighten it.
WARNING: Do not attempt to operate spindle lock button while the tool is
running.
Variable speed
The variable speed feature enables you to select the best speed for a particular application. Turn the variable speed dial to the left side for faster
speed, turn the dial to the right side to reduce the speed.
Swit
WARNING: Always check that the power supply is the same as that indicated
on the nameplate of the tool.
To switch on, depress the ON/OFF switch to "I".
To switch o , depress the ON/OFF switch to "O".
173

6. OPERATION

FR
ES
PT
IT
EL
PL
UA
RO
EN