Dexter 150MD2.5 Mentions Légales & Consignes De Sécurité page 167

i) Wear personal protective equipment. Depending on application,
use face shield, safety goggles or safety glasses. As appropriate,
wear dust mask, hearing protectors, gloves and workshop apron
capable of stopping small abrasive or workpiece fragments. The eye
protection must be capable of stopping flying debris generated by various
operations. The dust mask or respirator must be capable of filtrating particles
generated by your operation. Prolonged exposure to high intensity noise
may cause hearing loss.
j) Keep bystanders a safe distance away from work area. Anyone
entering the work area must wear personal protective equipment.
Fragments of workpiece or of a broken accessory may fly away and cause
injury beyond immediate area of operation.
k) Hold power tool by insulated gripping surfaces only, when
performing an operation where the cutting accessory may contact
hidden wiring or its own cord. Cutting accessory contacting a «live» wire
may make exposed metal parts of the power tool «live» and could give the
operator an electric shock.
l) Always hold the tool firmly in your hand(s) during the start-up. The
reaction torque of the motor, as it accelerates to full speed, can cause the tool
to twist.
m) Use clamps to support workpiece whenever practical. Never hold a
small workpiece in one hand and the tool in the other hand while in
use. Clamping a small workpiece allows you to use your hand(s) to control
the tool. Round material such as dowel rods, pipes or tubing have a tendency
to roll while being cut, and may cause the bit to bind or jump toward you.
n) Position the cord clear of the spinning accessory. If you lose control,
the cord may be cut or snagged and your hand or arm may be pulled into the
spinning accessory.
0) Never lay the power tool down until the accessory has come to a
complete stop. The spinning accessory may grab the surface and pull the
power tool out of your control.
p) After changing the bits or making any adjustments, make sure
the collet nut, chuck or any other adjustment devices are securely
tightened. Loose adjustment devices can unexpectedly shift, causing loss
of control, loose rotating components will be violently thrown.
2. SAFETY INSTRUCTIONS
167
FR
ES
PT
IT
EL
PL
UA
RO
EN