Before Putting The Equipment Into Operation - Dexter 150MD2.5 Mentions Légales & Consignes De Sécurité

FR
ES
NOTE:
PT
- the declared vibration total value has been measured in accordance with a standard test
method and may be used for comparing one tool with another;
IT
- the declared vibration total value may also be used in a preliminary assessment of
exposure.
EL
WARNING:
- the vibration emission during actual use of the power tool can
total value depending on the ways in which the tool is used;
PL
- Identify safety measures to protect the operator that are based on an estimation of exposure
in the actual conditions of use (taking account of all parts of the operating cycle such as the
UA
times when the tool is switched
Depending on the actual use of the product the vibration values can
RO
total! Adopt proper measures to protect yourself against vibration exposures! Take the whole
work process including times the product is running under no load or switched
consideration! Proper measures include among others regular maintenance and care of the
EN
product and application tools, keeping hands warm, periodical breaks and proper planning of
work processes!

5. BEFORE PUTTING THE EQUIPMENT INTO OPERATION

WARNING: The device should be disconnected from the mains before putting
into operation.
Installing accessories
DIFFERENT SIZE COLLETS ARE SUPPLIED TO ACCOMMODATE DIFFERENT SHANK SIZES.
1. Press spindle lock button and rotate the spindle by spanner until the lock button engages the spindle preventing further rotation.
2. Keep holding the lock button and loosen the collet nut.
3. Inserting the new accessory into the collet as far as possible to minimize running out and unbalance.
4. With the lock engaged, tighten the collet nut until the accessory shank is gripped by the collet. But excessive tightening of the collet nut is no
need.
NOTE: For precision work, it is important that all accessories be in good balance. You can
tell by the sound and feel it. To adjusting or balance an accessory, slightly loosen collet nut
and give the accessory or collet a desired turn if necessary.
4. TECHNICAL DATA
and when it is running idle in addition to the trigger time).
172
from the declared
from the declared
into