Functions - Triton TRA 001 Instructions D'utilisation Et Consignes De Sécurité

SYMBOLS
ENVIRONMENTAL PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check
with your local authority or retailer for
recycling advice.
Always wear ear, eye and respiratory
protection.
Conforms to relevant legislation
and safety standards.

FUNCTIONS

POWER SWITCH
When the router is connected
to power, the Switch (3) will
illuminate (in both 'on' and 'off'
positions).
The Retracting Switch Cover (4)
prevents accidental starting of
the router. It must be retracted
before the router can be switched on. The cover will
remain open until the router is switched off.
ADJUSTING THE DEPTH OF CUT
There are three methods of cut depth adjustment,
depending on the accuracy and control required:
• Free Plunge, for conventional and fast depth
adjustment
• Winder Handle Plunge, for controlled and fast
adjustment
• Micro Adjuster, for precise depth setting throughout
the full plunge range
Free Plunge
1. Free plunge depth
adjustments can be made
with the Plunge Mode
Selector Button (13)
engaged. Press it deep
GB
inside the handle until it
engages inward.
2. Release the Plunge Lock Lever (10). Push the body of
the router until the desired depth is reached. Re-lock
the plunge lock lever.
NOTE: The position of the plunge lock lever can be
altered by removing its retaining screw and repositioning
the lever on the bolt. Re-tighten firmly.
Symbols / Functions
6
Instruction warning.
Double insulated for additional protection.
Handle Winder Plunge
1. Check that the Plunge
Mode Selector Button
(13) is not engaged. If it is
engaged, press the button
inward and allow it to spring
out flush with the handle
2. Ensure the Plunge Lock
Lever (10) is unlocked
3. Pull the Winder Handle
Clutch Ring (14) into the
handle, then turn the handle
to raise or lower the cutter
4. Release the ring at the
required depth. It will 'pop
out' and lock the cutter at
the set depth
5. Lock the Plunge Lock Lever (10), particularly for heavy
cuts
Micro Adjuster
For use in Winder Handle Plunge Mode only
1. Disengage the Plunge Mode
Selector Button (13), and
ensure that the Plunge Lock
Lever (10) is unlocked.
NOTE: If the Micro Winder
(12) is turned with the
plunge lock lever engaged
the micro winder will start
clicking and the cut depth
will remain unchanged.
2. Turn the Micro Winder (12)
clockwise to increase cut
depth and anti-clockwise to
reduce cut depth.