Î Unpacking / Installation Precautions - Triangle SENSA Mode D'emploi

EN
UNPACKING
Open the box, and take out the speakers and accessories. If you notice any defects in one of the
elements as you unpack, please get in touch with your reseller.
Before disposing of the packaging, make sure there is nothing left inside. Each box contains :
1 x active SENSA speaker
Î
1 x passive SENSA speaker
Î
1 x remote (pull out the plastic tab from the battery compartment before use)
Î
8 x adhesive anti-slip feet to place below the speakers
Î
1 x AC power cord
Î
1 x 3 meters speaker cable to link the speakers
Î
1 x RCA cable to connect your sources
Î
1 x 1/8-inch (3.5mm) jack cable to connect your sources
Î
INSTALLATION PRECAUTIONS
Before the installation
Before making any connections, turn off the devices. Be sure to always set the active speaker switch
to OFF before removing or plugging connection cables. Do not plug in the power cord before all
connections are made.
Moving the device
Always remove the power cord and disconnect the cables between all components when moving
the device. This will prevent a short-circuit or the damage to the plugs or connection cables.
Before turning on the device
Check one last time if all the connections are correct.
Location to avoid
Install your speakers in a temperate place and avoid humid locations or direct sunlight.
Recycling
Protection of the environment: Your products contain valuable materials which can be recovered or
recycled. Take them to the appropriate collection points.
20