Î Adjusting The Amount Of Bass And Treble / Auto Standby Feature / Led On The Front Panel - Triangle SENSA Mode D'emploi

EN
BASS AND TREBLE ADJUSTMENT
Your SENSA speakers have a band equalizer that enables you to adjust the low and high frequencies
as you like.
Adjusting the amount of bass:
6 positions available in 2dB steps over a range between 30 and 400Hz.
(-6dB, -4dB, -2dB, 0dB, +2dB, +4dB, +6dB).
The factory setting defaults to 0dB.
The low-frequency output will increase or decrease each time the remote control is pressed.
Adjusting the amount of treble:
6 positions available in 2dB steps over a range between 2 and 30KHz.
(-6dB, -4dB, -2dB, 0dB, +2dB, +4dB, +6dB).
The factory setting defaults to 0dB.
The high-frequency output will increase or decrease each time the remote control is pressed.
When the speaker goes on standby, the settings will be stored for the next use.
To restore the factory presets, you just need to press the "RESET" button on the remote.
AUTO STANDBY FEATURE
If no signal is received for 15 minutes, the speakers will automatically switch to standby. To exit the
standby mode, simply switch the speakers back on with the remote.
HOW THE LED ON THE FRONT PANEL WORKS
The LED on the front panel switches off automatically after 10 seconds to avoid visual discomfort
while using the product.
Pressing on a button on the remote will turn the LED back on for 10 seconds.
28