GYS CUTTER 45 CT Mode D'emploi page 22

- The machine does not switch on.
- The pilot-arc cuts out too quickly
- The arc stops mid-way through cutting
- Premature wear of consumables
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
22
CUTTER 45 CT
No power supply
Used consumables
cutting speed too low on thin sheets
Contact on the low-quality earth clamp
Cutting height too high
Cutting current inappropriate for consu-
mables used
Inappropriate air pressure
Humid air
EN
Check that the power cord of the pro-
duct is plugged into the outlet and that
the power switch is in the on position.
Check that the circuit-breaker has not
tripped.
Check the condition of the consumables
and replace if necessary.
Reduce the current / increase the
movement speed.
Check that the earth clamp is connec-
ted to the cutting part on a clean area
(no rust, paint or grease).
Use a cutting pad and keep it in contact
with the part to be cut.
Refer to the chapter "Setting the cut-
ting current".
Refer to the chapter "Adjusting the air
pressure".
Purge the air filters from the station
and the compressed air network. Add
the additionnal Air filter ref. 039728.