GYS CUTTER 45 CT Mode D'emploi page 18

For cutting:
One caliber of consumables is available:
- small work with the nozzle 20-50 A marked «45 A»
TORCH SETUP (IPT-40)
The torches are cooled with ambient air and do not require any special cooling.
1 - CONSUMABLES LIFE CYCLE
The replacement frequency of the Plasma's consumables depends on several factors:
• The metal thickness.
• The average cutting time
• The air quality (presence of oil, humidity or other contaminants).
• The metal piercing or the cut from the edge.
• The adequate distance between the torch and the part when cutting.
In normal conditions :
- During manual cutting, the electrode wears out first.
Torch consumables :
040236
Nozzle
2 - INSTALLATION OF THE TORCH CONSUMABLES :
Before changing the consumables, cut the power supply using the interrupor behind the machine.
To use the torch, a complete set of consumables must be installed in the correct order: electrode, diffuser, tip and nozzle.
AIR PRESSURE ADJUSTMENT
In order to improve cutting performance, make sure air pressure is set to an appropriate level.
18
CUTTER 45 CT
040175
040212
Tip Di user
Nozzle Tip
Manual cutting
20-50 A
037564
037557
(x 5)
Automated cutting
20-50 A
037564
037557
(x 5)
040168
Electrode
Diffuser Electrode
EN
037571
037601
(x 5)
037571
037601
(x 5)
4 m
Torch
037625
037649