Programming The Coffee-Cappuccino Sequence; To Reset The Original Factory Programme - Wega LB 4700 Manuel D'utilisation

8.3

PROGRAMMING THE COFFEE-CAPPUCCINO SEQUENCE

The machine allows you to decide which sequence to use when dispensing cap-
puccino.
In particular, there are three options:
a) Delivery of milk first, then coffee.
b) Delivery of coffee first, then milk.
c) Simultaneous delivery of milk and coffee.
To decide which of the three options to use, proceed as follows:
• Turn the machine off by moving the power switch to position 0;
• press and hold the button of the push button panel regarding the desired op-
tion (see figure alongside) and simultaneously turn the machine back on: the
LED of the button pressed will come on;
• confirm by pressing the PROG/STOP button (2).
The machine will now use the set sequence.
The machine is programmed for simultaneous delivery of milk and coffee (mode c) .
8.4

TO RESET THE ORIGINAL FACTORY PROGRAMME

To reset the original factory programme, proceed as follows :
• Set the programming lever (1) under the top grill of the machine to the ON position;
• Turn on the machine by pressing simultaneously button (2)
• Confirmation that the default data program has been reset is indicated when the LEDs of both buttons turn on;
• Turn the programming lever (1) under the upper grill of the machine to the OFF position.
All programming operations must be made by qualifi ed technical personnel.
Take care when accessing the inside of the machine to set the programming lever: some of the
components are scalding hot and there are parts under electrical tension .
espresso coffee machine - user instructions
1
a
b
a) Deliver milk first, then coffee.
b) Deliver coffee first, then milk.
c) Simultaneous delivery of milk
and coffee.
and button (3) for at least 5 seconds;
2
3
0
1 2
c
2
English
71