JB Systems Light Led pipe rgb 230V Mode D'emploi page 5

ENGLISH
 SOUND MODE (DIP3 = ON - DIP4 = OFF)
DIP10 = switch ON for pattern inversion
Random mode (7 chases)
Color change by sound in two way chase
One color in one way
One color in two way
Multicolor in one way
Multicolor in two way
Color change by sound
Color change in strobe
 dB MODE (DIP3 = OFF - DIP4 = ON)
DIP10 = switch ON for pattern inversion
Random mode (7 chases)
Multicolor chase light with red base color
Multicolor chase light with green base color
Multicolor chase light with blue base color
Multicolor chase light with black base color
VU-meter with green/yellow/red color
Multicolor VU-meter 1
Multicolor VU-meter 2
 HOLD MODE (DIP3 = ON - DIP4 = ON)
DIP10 = not used
All tubes white
All tubes red
All tubes green
All tubes yellow
All tubes blue
All tubes purple
All tubes cyan
All tubes white
JB SYSTEMS
®
OPERATION MANUAL
5/34 LED PIPE RGB 230V
ENGLISH
OPERATING INSTRUCTIONS
 Once connected to the mains the devices start running.
 You can also connect the units to the LED PIPE controller for extra functions and DMX-control. When
used with the controller, please also check its user manual.
 Do not switch the unit on and off in short time intervals as this reduces the lamp life.
 Always unplug the unit when it is not used for a longer time or before replacing the bulb or start servicing.
 In the event of serious operating problems, stop using the fixture and contact your dealer immediately.
 Important: Don't use the effect in the presence of persons suffering from epilepsy.
MAINTENANCE
 Make sure the area below the installation is free from unwanted persons during servicing.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 The cleaning of external optical lenses and/or mirrors must be carried out periodically to optimize light
output. Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or
particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics.
 Clean with a soft cloth using normal glass cleaning products.
 Always dry the parts carefully.
 Clean the external optics at least once every 30 days.
SPECIFICATIONS
Mains Input: AC 230V, 50Hz
Power consumption: 18Watt
Number of LEDs: 144 pcs (48 red, 48 green, 48 blue)
Different LED sections: 16
Beam Angle: 120°
Life span of LEDs: 50000 ~ 100000 hours
Sound control: Internal microphone
Size: 1000 x 62 x 100mm
Weight: 1.6kg
Every information is subject to change without prior notice
You can download the latest version of this user manual on our website: www.beglec.com
JB SYSTEMS
®
OPERATION MANUAL
6/34 LED PIPE RGB 230V