REMIS REMIfront T5 Notice De Montage page 18

B21
US/GB
B22
B23
B24
B25
B26
18/64
B21 + B22: (Preparation for the assembly of the A-pillar
panelling)
If necessary, mark the contour of the A-pillar panelling on
the vehicle's roof lining. Then remove any excess material.
B23 - B25: (Assembly of the A-pillar panelling)
Insert the new panel into the designated space on the
dashboard from the top and press it onto the A-pillar. In
doing so, make sure that both rivets from the fastening are
in the correct position and make sure that the edge of the
A-pillar panelling remains in the groove of the door seal.
Make sure that the clip-on connections are engaged!
If necessary, press the edge of the A-pillar panelling that
has popped out back into the seal groove with the aid of a
suitable tool.
B26: (Assembly of the entry handles)
It is now time to assemble both of the entry handles. Be-
fore screwing the handles, check if the wiring harnesses
are not lying in front of the thread. If this is the case, press
them carefully in the direction of the door seal with the aid
of a suitable tool.