Important Notice - REMIS REMIfront T5 Notice De Montage

B. Information on assembly
First read through this information carefully. This system is not suitable for
vehicles with airbags in the A-pillars or above the doors!
Installation should only be carried out with both entry handles. For vehicles
with a handle installed on one side on the A-pillar, it is imperative that you
We recommend that the installation of the blackout system is carried out
by a specialist workshop! We assume no liability or warranty for improper
Step 1: (Check the vehicle's equipment)
B1
1
2
4
3
Step 2: (Check the scope of delivery)
B2
B3

Important notice!

install the second handle and fastening!
installation.
B1:
Attention: The item is not included in the scope of
delivery and must be purchased separately as re-
quired! An entry handle must be available on each
side of the A-pillar in order to install the blackout
system in the vehicle:
5
1 x angle bracket on the left (3)
1 x angle bracket on the right (3)
1 x hand-grip on the left (2)
1 x hand-grip on the right (2)
2 x cover caps (1)
4 x hexagon socket oval head screws M6 x 35 (4)
6 x hexagon socket flat­head screws M6 x 12 (5)
B2:
Front system:
Panelling A-pillar FS & BFS
Upper guide pipe FS (660 mm) & BFS (715 mm)
Lower guide pipe FS (742 mm) & BFS (822 mm)
Fascia panel above FS & BFS
2 x ventilation ducts (left and right)
2 x air inlet screens (left and right)
B3:
Accessories for the front system:
1 bracket pipe
1 self-adhesive foam strip 450 x 10 x 10
2 screws SK4.2 x 13
6 wall plugs
2 set screws M4 x 40
2 panes 5.3 x 1
2 nuts M4
US/GB
13/64