Publicité
Les langues disponibles
Les langues disponibles
ADVICE
To avoid making deep scratches on the plate, do not cut your food directly on it.
Do not leave kitchen utensils on the plancha, such as cutlery, wooden spoons, plastic
utensils, etc.
Do not cook at too high a temperature as this may char the plate and make it difficult to
clean.
The plancha can be used for keeping food warm at the end of cooking by adjusting the
lever to the low flame.
For all of our recommendations for use and recipes, go to our website at
www.krampouz.com.
SWITCHING OFF THE PLANCHA
- After use, switch off your appliance by placing the lever or levers vertically to the
large full circle position.
- Close the valve on the gas cylinder
- Disconnect the supply hose from the appliance and store it in a dry, well-ventilated
place. The gas cylinder must also be stored in a dry, well-ventilated place, away
from any source of heat.
Adjustments
When changing the type of gas, always change the injectors (see instructions in the
table on page 16).
CHANGING THE INJECTORS
On an installed appliance, before changing the injectors and making the new
adjustments, close the valve on the supply pipe or gas cylinder.
Perform the following operations:
-
Close the valve on the supply pipe or gas cylinder.
GGCIR2
-
Turn the appliance, remove the galvanised steel plate and unscrew both screws
on the injector support (see figure 2 page 66-67)
-
Remove the injector from the burner hole.
-
Unscrew the injector with a size 7 wrench, then take the transformation bag
(injector bag).
-
Change the injector and its seal, as indicated in the table for the different supply
types (table on page 27, injector marking and air collar opening).
- 28 -
Publicité
