FujiFilm FUJINON Premista28-100mmT2.9 F/M Mode D'emploi page 29

CAUTION
Provide support for the Lens by using the Bridge Plate and Lens Support to protect the Lens
and camera mount.
WARNING
Be sure to attach all the parts securely. Dropping any parts from a height may cause severe
accidents.
SLIT (4 PLACES)
LENS
BRACKET
LENS SUPPORT
◎ The installation procedure is as follows:
a. Attach the Camera and the Lens Support to the Bridge Plate.
（The installation procedure varies depending on the Bridge Plate to be used.）
b. Fully turn the camera's mount clamp ring counterclockwise to loosen it.
c. While holding the Lens by hand, align the mounting surface of the Lens and that of the Camera.
((Align the Camera with the Lens so that the pin on the mounting surface of the Camera is securely inserted
in the slit on the mounting surface of the Lens.)
d. Temporarily fix the Camera and Lens by slightly turning the camera's mount clamp ring clockwise.
e. While holding the Lens by hand, adjust the position and height of the Lens Support. Do not apply excessive
force to the mounting portions of the Camera and Lens while adjusting the position and height.
f. Fully turn the camera's mount clamp ring clockwise and fix the Camera and Lens firmly.
Note. Make sure to adjust the flange focal length when installing the lens on a camera for the first time or
installing it on another camera (refer to page 5).
Note. For the installation method of the Bridge Plate and Lens Support, refer to the operation manual that came
with each product.
CAUTION Carefully adjust the position and height of the Lens Support. If excessive force is applied to the
mounting portions of the Lens and Camera, this may damage the Lens or Camera mounts.
４. INSTALLATION
MOUNT FACE OF LENS
SUPPORT ROD
MOUNT CLAMP RING
-  -
MOUNT FACE OF CAMERA
PIN
(POSITION DEPENDS
ON CAMERA)
CAMERA
BRIDGE PLATE
TRIPOD