Philips HD7766 Mode D'emploi page 6

4 Before first use
4.1 Setting the clock
Put the mains plug in the wall socket.
1
•
00:00 flashes on the display to indicate
that you have to set the clock time.
Turn the knob to set the hour (Fig. 2).
2
Press in the centre of the knob to confirm the
3
hour (Fig. 3).
•
The minutes start to flash to indicate that
you have to set the minutes.
Turn the knob to set the minutes (Fig. 4).
4
Press in the centre of the knob to confirm the
5
minutes (Fig. 5).
The display shows the set clock time.
6
The coffeemaker is ready for use.
4.2 Setting the automatic
switch off time
You can adjust the time after which the appliance
automatically switches off. The default time is set to
30 minutes. You can adjust this time to a maximum
of 120 minutes. If you want to adjust the automatic
switch off time, follow the steps below.
Make sure the appliance is switched off
1
(but the mains plug is in the wall socket).
Press and hold in the centre of the knob until
2
the display starts to flash.
Turn the knob to increase or decrease the
3
time. 1 is 10 minutes, 2 is 20 minutes,
3 is 30 minutes and so on until 12 is 120
minutes.
Press in the centre of the knob to confirm the
4
minutes.
Note:
D
The appliance always saves the last setting.
6
4.3 Flushing the appliance
You need to flush the coffeemaker once before
first use.
Open the water reservoir lid. Fill the water
1
reservoir with fresh cold water up to the
8-cup indication. (Fig. 6)
Note:
D
Do not put coffee beans or ground coffee in
the appliance.
Close the water reservoir lid.
2
Put the jug in the appliance (Fig. 7).
3
Press the on/off button (Fig. 8).
4
•
The display lights up.
Press the strength select button (Fig. 9).
5
Turn the knob to choose the pre-ground
6
coffee setting (Fig. 10).
•
The pre-ground coffee icon lights up.
Press in the centre of the knob to confirm.
7
Then press in the centre of the knob again to
start the flushing process (Fig. 11).
Let the appliance operate until the flushing
8
process has been completed.
Empty the jug.
9
5 Using the appliance
5.1 Filling the water reservoir
Open the water reservoir lid and fill the water
1
reservoir with the required amount of cold
water. (Fig. 6)
When you open the water reservoir lid, there
are indications for 2 to 10 cups on the inside
of the appliance. You can use these indications
to determine how much water to put in the
water reservoir. The reflection changes from
light to dark per filled cup of water. You can
also use the water level indicator on the jug.
Note:
D
Do not fill the water reservoir beyond the
10-cup indication.