Fuse Check/Replacement/Reset - Clarke Vantage 14 Mode D'emploi

FUSE CHECK/REPLACEMENT/RESET

Drive the machine on a level loor.
1.
2. Check that the function selection knob (31) is turned to "0"
and disconnect the battery connector (7).
3. Open the cover (4) and check one of the following fuses
for deactivation or integrity (Fig. 8):
•
(A): F1 (35 A) circuit breaker, brush motor.
•
(B): F2 (30 A) blade fuse, vacuum system motor.
•
(C): F3 (5 A) blade fuse, accessories.
Reset or replace any fuse, after having checked and
repaired any problem that caused deactivation.
4. Close the cover (4).
INSTRUCTIONS FOR USE
C
B
Figure 8
9099878000 - VANTAGE 14
ENGLISH
A
P100414
19