Door Seals Cleaning; Troubleshooting - Electrolux EN6086JOX Notice D'utilisation

Masquer les pouces Voir aussi pour EN6086JOX:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 46
18
www.electrolux.com

9.3 Door seals cleaning

Take care to keep door seals clean.
Sticky food and drinks can cause seals
to stick to the cabinet and tear when you
open the door. Wash seal with a mild
detergent and warm water. Rinse and dry
it thoroughly after cleaning.

10. TROUBLESHOOTING

If you experience a problem with your
appliance or are concerned that the ap-
pliance is not functioning correctly, you
can carry out some easy checks before
calling for service, please see below.
You can carry out some easy checks
according to this section before calling
for service.
Problem
Appliance is not
working correctly
Odours from the com-
partments
Noise from the appli-
ance
150213_UM of FrenchDoor-Electrolux-EN-ET-FR-IT-LV-LT-PL-PT-RO-RU-ES-DK-FI-SV-NO-TR-UK.indd 18
Possible cause & Solution
Check whether the power cord is plugged into the power
outlet properly.
Check the fuse or circuit of your power supply, replace if
necessary.
It is normal that the freezer is not operating during the
automatic defrost cycle, or for a short period of time after
the appliance is switched on to protect the compressor.
The interior of the refrigerator may need to be cleaned.
Some food, containers or wrapping cause odours.
The sounds below are quite normal:
Compressor running noises.
• Air movement noise from the small fan motor in the
freezer compartment or other com-partments.
• Gurgling sound similar to water boiling.
• Popping noise during automatic defrosting.
• Clicking noise before the compressor starts.
Other unusual noises are due to the reasons below and
may need you to check and take action:
The cabinet is not level.
The back of appliance touches the wall.
Bottles or containers fallen or rolling.
CAUTION!
Only after the door seals are com-
pletely dry should the appliance be
powered on.
WARNING!
The LED light must not be re-
placed by the user! If the LED light
is damaged, contact the customer
helpline for assistance.
WARNING!
Don't try to repair the appliance
yourself. If the problem persists
after you have made the checks
mentioned below, contact a quali-
fied electrician, authorized service
engineer or the shop where you
purchased the product.
2016-09-26 08:18:17

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

En6086mox

Table des Matières