Door Removal - Electrolux Kenmore Elite 253.4474 Serie Guide D'utilisation Et D'entretien

Door Removal Instructions
Door Handle Mounting Instructions
1. Remove handle from carton and any other protective
packaging.
2. Position refrigerator handle end caps over upper
and lower pre-installed shoulder bolts (A) that are
fastened into door, ensuring the holes for the set
screws are facing towards the outside of door if it is
a single unit installation, or towards the freezer door
if installing the matching freezer.
3. While holding handle firmly against door, fasten
upper and lower Allen set screws (B) with supplied
Allen wrench.
4. Repeat steps 2 and 3 to install freezer handle (if
installing the matching freezer). Ensure the holes for
the set screws are facing towards the refrigerator
door.
NOTE
All set screws should be tightened and sub-flush of
handle end cap (Allen set screw should be seated just
below the surface of the end cap). The end caps should
be drawn tight to refrigerator door with no gaps.
A
Single Unit Installation
Ensure Handle Set Screws
are Facing Each Other
With Doors Closed.
Matching Refrigerator and Freezer Door Handle
B
Installation
Kick Plate Removal
To remove the kick plate, use a Phillips head screwdriver
and remove the two screws holding the kick plate to the
cabinet. Then pull the kick plate away from the unit.
Kick Plate Removal
8
Remove Screws