Operation; Switching On And Off; Measurement Procedure - Trotec T60 Manuel D'utilisation

4. Operation

Switching on and off

Remove the protective cover
. This procedure automatically switches the instrument on. Place
the protective cover during the measurement procedure on the
upper face of the instrument
cover on the lower face of the instrument. By means of this procedure
the instrument automatically switches itself off.
Automatic switch off: If an instrument that is switched on is not used
for any measurement within a period of approx. 15 minutes, the instru-
B - 06
from the lower face of the instrument
. To switch off replace the protective
Operating manual – English
ment automatically switches itself off to preserve battery life. In order to
bring the instrument back into the switched-on state, push briefly on the
activation pin that is fitted between the electrode pins

Measurement procedure

Create a solid connection between the electrodes and the material by
pushing the electrode pins
of wood the electrodes should be pressed in at right angles to the grain
of the wood. Repeat the measurement procedure at a number of
positions as necessary in order to achieve a higher accuracy from the
arithmetic mean of the results.
.
securely into the material. In the case