Steam Ironing; Dry Ironing - Beper 50.946 Manuel D'instructions

Steam iron Use instructions
When the cloth is made of several fabrics, set the temperature for the most delicate fa bric.
If you do not know the type of fabric we recommend to iron the internal parts of clothing, from lowest
temperature, and then finding the temperature more adapted. If clothing be comes "brilliant", stop
immediately in order to not damage it. Then start to iron it on the back.
N.B. Pay attention to the symbol : that means that the fabric must not be iro ned.

STEAM IRONING

Before plugging the appliance, make sure the tank is full of water.
Check the steam indicator is on position to use steam function.
When used for the first time, press several times steam switch, in order to eliminate dirt, residue
from the manufacture.
Steam ironing is possible when setting the thermostat on symbol (•) ; when the tempe rature increa-
sed the steam also increase until symbol max. (•••).
The light indicator illuminate and when the soleplate is at good temperature switch off.
Set the temperature indicator at least on position "•••".
Wait 5 seconds between steam spray and the one other after.
If steam switch (4) is pressed before reaching the setting temperature, steam func tion won't work
but only water drops; that could stain clothes.
Water drops may result of a non-stop pressure of steam switch, by more than 5 se conds.
To obtain a non-stop steam, keep steam indicator in position
ATTENTION : always direct the steam to clothes and not in direction of face.
When finished using the iron, unplug the appliance and empty the tank water.

DRY IRONING

Set the steam indicator on in order to not to use steam function simbolo no vapour. Set the soleplate
temperature by using the thermostat. The light indicator illuminates and switch off when the sole-
plate is at good temperatu re.
Start ironing after iron reached desired temperature. Please note that the soleplate reached lower
temperatures when used without steam.
FILL AND EMPTY THE TANK
This has to be made only when the appliance is unplugged.
Always dry the iron or hands before unplug the appliance after filling the tank.
Make sure the temperature indicator is on "min" and steam indicator is on simbolo no vapour. Slowly
fill using a funnel
Do not exceed the maximum limit of the tank.
Do not introduce water into the iron, because of electric shock risks. Plug the appliance to the so-
cket. It is possible to use tap water as well as demineralised water if tap water is to hard.
After ironing, unplug the appliance from the socket and empty the tank.
To empty the tank turn over the iron above the sink (or other).
13