HTW A60CGN8PLUS Manuel De L'utilisateur page 114

Use the correct screwdriver to tighten the terminal screws. Small screwdrivers can damage the screw head and prevent
appropriate tightening.
Over-tightening the terminal screws can damage the screws.
Attach a ground fault circuit interrupter and fuse to the power supply line.
In wiring, make certain that prescribed wires are used, carry out complete connections, and fix the wires so that outside force
cannot affect the terminals.
Safety device requirements
8.8.4
1. Select the wire diameters( minimum value) individually for each unit based on the table below.
2. Select circuit breaker that having a contact separation in all poles not less than 3 mm providing full disconnection，where
MFA is used to select the current circuit breakers and residual current operation breakers:
System
60
100
160
60(3kW heater)
100(3kW heater)
160(3kW heater)
60(9kW heater)
100(9kW heater)
160(9kW heater)
8.8.5 Specifications of standard wiring components
Equipment main Power Supply Wiring
LPS
Stated values are maximum values (see electrical data for exact values).
Voltage
Hz
(V)
50 220-240/1N
50 220-240/1N
50 220-240/1N
50 220-240/1N
50 220-240/1N
50 220-240/1N
50 380-415/3N
50 380-415/3N
50
380-415/3N
XT1
INDOOR UNIT
POWER SUPPLY
L N
33
Power Current
Min. Max. MCA
(V) (V) (A)
198 264 1.20
198 264 1.20
198 264 1.20
198 264 14.30
198 264 14.30
198 264 14.30
342 456 14.00
342 456 14.00
342 456 14.00
IFM
MFA FLA
KW
(A) (A)
/ 0.087 0.66
/ 0.087 0.66
/ 0.087 0.66
/ 0.087 0.66
/ 0.087 0.66
/ 0.087 0.66
/ 0.087 0.66
/ 0.087 0.66
/ 0.087 0.66