Petsafe Staywell Magnetic 400 Serie Guide De L'utilisateur page 3

Before installing your cat fl ap please
read the following step-by-step
instructions carefully.
Tools required
• Pencil
• Ruler
• Jig or Keyhole Saw
• Drill
• Screwdriver
• Tape measure
• Glue
• Sand paper
Measurement and marking
Measure the belly height of your cat. This is usually 100 -150mm (4-6") (Fig. 1).
Mark this measurement on the outside of your door and draw a straight
horizontal line 168mm (6 1 / ") (Fig. 2).
2
Usually this line will be the bottom of the hole you cut in your door – the
frame of the cat fl ap will be slightly lower. With Magnetic cat fl aps it is
important that the cat is able to approach the cat fl ap without obstacle. There
should be a level area in front of the cat fl ap outside which is suffi cient for
the cat to stand with all four paws on the same level.
2
FIG.1
Cutting a hole for your cat fl ap
a) In Wood
Wooden doors
The cat fl ap requires a square cut-out of 175mm x 168mm (6
168mm (6 / ")
1
2
Not to scale - for best results you should refer
to the enclosed cutting template.
FIG.2
3 / " x 6 1 / "). (Fig. 3).
4 2
175mm
(6 3 / ")
4