Important - Hoshizaki KM-520MAJ-E Notice D'installation

IMPORTANT

1. In order to carry out safe and proper
installation of the product, please read this
booklet carefully beforehand and follow the
instructions contained within.
2. On completion of the installation, start the
icemaker to check for any abnormalities,
and instruct the user on how to use and
maintain the icemaker in accordance with
the Instruction Manual.
3. This booklet should be handed over to the
user after the installation and be preserved
by the user together with the Instruction
Manual for any further consultation that
may be necessary.
WARNING
The installation must be carried out by
qualified personnel, in accordance with
current regulations, according to the
manufacturer's instructions.
1. Unpacking
WARNING
Children should not be allowed in reach of the
packaging elements (plastic bags and expanded
polystyrene) as they are potential sources of
danger.
NOTICE
Remove shipping carton, tape(s) and packing.
If packing material is left in the icemaker, it will
not work properly.
Note: This icemaker needs a storage bin. The
recommended storage bin is HOSHIZAKI ICE
STORAGE BIN, Model B-300 series.
1) After removing the packaging, make sure that the
icemaker is in good condition. If in doubt, please do
not use the equipment but apply to professionally
qualified personnel. See the instruction sheet
attached to the storage bin for its unpacking and
installation guidelines.
2) Remove the panels to prevent damage when
installing the icemaker. (See "2. How to Remove
Panels.")
3) Remove the package containing the accessories
from the compressor compartment.
4) Remove the protective plastic film from the panels.
If the icemaker is exposed to the sun or to heat,
remove the film after the icemaker cools.
5) Check that the refrigerant lines do not rub or touch
lines or other surfaces, and that the fan blade turns
freely.
6) Check that the compressor is snug on all mounting
pads.
7) See the nameplate on the rear panel, and check
that your voltage supplied corresponds with the
voltage specified on the nameplate.
8) Remove the shipping tapes securing the cube
guide.
2. How to Remove Panels - See Fig. 1
Insulation
Panel
Base Cover
Front Panel
Fig. 1
a) Front Panel: Remove the screw, lift up towards you.
b) Top Panel: Lift up at front slightly, push rearward
and lift off.
c) Side Panel (R): Remove the screw, slide forward
slightly, and lift off.
d) Insulation Panel: Lift up slightly, and pull towards
you.
e) Base Cover: Lift up slightly, and pull towards you.
2
Top Panel
Side
Panel