Assembling The Hedge Trimmer; Mounting The Loop Handle (Hla 66); Removing And Fitting The Battery; Inserting The Battery - Stihl HLA 66 Notice D'emploi

English

7 Assembling the Hedge Trimmer

7.1

Mounting the Loop Handle (HLA 66)

► Switch off the long-reach hedge trimmer and remove the
battery.
5
6
7
► Fit the clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the shaft (5).
► Fit the washers (2) on the screws (1).
► Press the clamp (6) against the shaft (5).
► Insert the screws (1) through holes in the loop handle (3)
and clamps (4 and 6).
► Fit and tighten down the nuts (7) firmly.
46
1
1
2
2
3
4
7

8 Removing and Fitting the Battery

8.1

Inserting the battery

1
2
► Insert the battery (1) up to the limit stop into the battery
compartment (2).
The battery (1) engages with a click and is now locked.
8.2

Removing the Battery

► Lay the long-reach hedge trimmer on a level surface.
► Keep one hand in front of the battery compartment so that
the battery (2) cannot fall out.
► Press both locking levers (1).
The battery (2) is released and can be removed.
7 Assembling the Hedge Trimmer
1
1 2
0458-185-9621-A