Download App / Pc Software Brematicpro; Pairing The Wireless Wall Switch Directly With Brematicpro Devices; Pairing The Wireless Wall Switch With The Brematicpro Gateway - brennenstuhl BrematicPRO APWT 868 01 IP44 3726 Mode D'emploi

Wireless wall switch4 868.3 MHz

Download app / PC software BrematicPRO

The Brennenstuhl Home Automation Systems BrematicPRO is
controlled via the BrematicPRO app/PC software. The app can be
downloaded for free from the App Store and Google Play. The PC
software is available for download at www.brematic.com/en/service.
Please follow the on-screen instructions for download and installation.
For more information about the app and how to use it, please visit
www.brematic.com/en/service.
Pairing the wireless wall switch directly with
BrematicPRO devices
The wireless wall switch can be paired directly with the BrematicPRO
wireless switch adapter or wireless flush-mounted actuators. Two
separate buttons are integrated within the wireless wall switch. You
can use the upper part of the rocker switch for switching a wireless
switch adapter and the lower part for switching a wireless flush-
mounted actuator, for example.
Press and hold the pair button of the components to be paired for
3 seconds.
The LED will flash red.
16 EN
While the LED is flashing, press the upper part or lower part of the
rocker switch on the wireless wall switch you would like to use.
Once both devices have been paired the device LED will briefly light
up red. This completes the pairing process. The device LED will flash
thrice if there has been a transmission error. Check that the device to
be paired is connected.
Pairing the wireless wall switch with the
BrematicPRO Gateway
When linked with the Home Automation Systems BrematicPRO via
the BrematicPRO Gateway, you can use the app/BrematicPRO PC
software to use additional software-based functions, e.g. functions
such as controlling actions (tasks), switching devices on / off.
The app or BrematicPRO PC software is installed and open.
The BrematicPRO Gateway is ready for use.
Keep the device at least 50 cm from the gateway.
Open the "Settings" menu.
Select the room where you wish to use the device.
Select "Add Device".
Select the frequency "868 MHz".
Under "New Device", select "Switch / Socket" and click "Continue"
to confirm your selection.
Follow the on-screen instructions.
Press the upper or lower part of the rocker switch on the wall
switch. Only one rocker switch has to be programmed for the
wall switch to be fully integrated within the system.
Enter a device name, e.g. "Wireless Wall Switch".
Select "Add" to assign the device to the room.
First tap "Back" to leave the room, then "Done" to complete the
pairing process.
The wireless wall switch is now connected to the Home
Automation Systems BrematicPRO.
Use "Test Device" to switch the consumer on and off to ensure
the wireless wall switch is working properly.
Upper button
Lower button