Installation; Installation Using Screws; Installation Using Adhesive - brennenstuhl BrematicPRO APWT 868 01 IP44 3726 Mode D'emploi

Remove the rocker switch from the cover frame.
Rotate the battery cover into the OPEN position using a coin,
for example, to open the battery compartment.
Remove the drained battery if required.
Insert the battery into the battery compartment with correct
polarity (+ pole pointing upwards).
Close the battery cover and secure it by rotating it into the CLOSE
position.
Press the rocker switch onto the cover frame until both catches
click audibly into place.
The wireless wall switch is now ready for use.
Wireless wall switch4 868.3 MHz

Installation

Note: Check before installation whether the product is located
within the range of the Gateway.
The wireless wall switch can be installed using an adhesive pad or
screws on any surface.
An eaves, for example, is particularly suitable for outdoor installation.
Install the wireless wall switch with the marking ( UP) on the
installation plate pointing upwards on the wall.

Installation using screws

1 x 3 V Battery (CR2450)
CAUTION! DANGER OF ELECTRIC SHOCK!
Make sure that you do not damage electrical cables
in the wall during installation.
Remove the rocker switch. Press the installation plate backwards
until the cover frame of the installation plate comes off the catches.
Draw the four drill holes on the wall using a pen, with the help
of the installation plate.
Drill the marked holes using a suitable drill and insert the dowels.
Screw the installation plate to the wall using the screws provided.
Note: When installing on a wood surface, use a 1.5-2 mm drill.
You will not require any dowels.
Press the cover frame onto the installation plate until it audibly
clicks into place.
Press the rocker switch onto the cover frame until both catches
click audibly into place.

Installation using adhesive

Ensure that the installation area is clean, dust-free and dry.
Avoid installation locations which are under the strong influence
of heat (i.e. sunlight) as the adhesive tape can come unstuck.
Attach the adhesive pad enclosed to the back of the device.
Affix the wireless wall switch by gently pressing it onto the desired
installation area.
EN 15