Download App / Pc Software Brematicpro; Pairing The Wireless Direct Wire Wall Switch With The Brematicpro Wireless Remote Control - brennenstuhl BrematicPRO UPWS 868 01 W1000 3726 Mode D'emploi

Wireless direct wire wall switch 868.3 MHz
CAUTION! DANGER OF ELECTRIC SHOCK!
Only install the device in a de-energised state! Disconnect the
electrical mains supply line by switching off the circuit breakers
connected to it or unscrewing the fuse. Prevent this from being
unintentionally re-started e.g. with a warning sign.
Before installation, check the mains supply line with a suitable
measuring device to see that it is de-energised.
The mains voltage on site must correspond with the technical
data of the device (see "Technical data").
Check the power input of the consumer you intend to connect
to the device prior to installation. The maximum load is approx.
1000 W.
The device must be operated in a suitable flush-mounted box
or surface mount box or assembled in another suitable casing to
guarantee the necessary electric shock protection.
Only operate the device when it is stationary.
Remove the cover frame from the electronic unit.
L
N
PE
12 EN
Connect the supply voltage cable to the screw terminals L-IN
and N-IN (N = neutral conductor, L = phase) (see Fig.).
Connect the consumer to the screw terminal L-OUT. The N
conductor can alternatively be connected to the wall switch
N-OUT.
For consumers with a PE / ground conductor connection, the
ground conductor must be connected.
Attach the wireless direct wire wall switch to the flush-mounted box
using screws (hole spacing for mounting eyes = 60 mm).
Latch the switch cover onto the electronics casing.

Download app / PC software BrematicPRO

The Brennenstuhl Home Automation Systems BrematicPRO is controlled
via the BrematicPRO app/PC software. The app can be downloaded for
free from the App Store and Google Play. The PC software is available
for download at www.brematic.com/en/service.
Please follow the on-screen instructions for download and installation.
For more information about the app and how to use it, please visit
www.brematic.com/en/service.
Pairing the Wireless direct wire wall switch with
the BrematicPRO Wireless Remote Control
The wireless direct wire wall switch can be paired directly with the
BrematicPRO wireless remote control.
Press and hold the pair button for 3 seconds.
The LED will flash red.
Whilst the LED is flashing, press a button on the left of the
BrematicPRO wireless remote control you wish to programme
for the device. Once the devices have been paired, the LED will
light up green and the wall switch will be switched on. This
completes the pairing process.