Intended Use; Information About Wireless Operation; Duty Cycle; Included In Delivery - brennenstuhl BrematicPRO APWT 868 01 IP44 3726 Mode D'emploi

Risk of device damage
Only use the specified battery type!
Please note the correct polarity when inserting the battery!
If necessary, clean the battery and device contacts before inserting
the battery!
Promptly remove drained batteries from the device!
WARNING! CHEMICAL BURNS!
Keep batteries away from children.
The device contains a lithium button cell. If a new or drained button
cell is swallowed or enters the body it can lead to severe internal
chemical burns and can cause death within two hours of ingestion.
Always ensure that the battery compartment is securely shut. If the
battery compartment does not close correctly, stop using the device,
remove the battery and keep it away from children.
If you believe that a button cell has been swallowed or has
entered someone's body, seek immediate medical attention.
The batteries must be disposed of correctly, even if they have
been kept away from children.
Even used batteries can cause injuries.

Intended use

This device is suitable for outdoor use; it complies with protection
type IP44.

Information about Wireless Operation

This device uses the 868.3 MHz proprietary wireless protocol. Wireless
transmission is implemented using a non-exclusive channel, interference
can therefore not be excluded.
The range in buildings may vary greatly from open areas. In addition to
the transmission power and the reception characteristics of the receivers,
ambient conditions, e.g. humidity in addition to the structural conditions
on site, are important factors.
The range can be significantly reduced in part due to:
• Wood, gypsum, concrete, reinforced concrete walls
• Proximity to metal and conductive objects
• Broadband interference, e.g. in residential areas (DECT phones,
mobiles, wireless headphones, wireless speakers, wireless
weather stations, baby monitors)
• Proximity to electric motors, transformers, mains adapters,
computers
Wireless wall switch4 868.3 MHz

Duty Cycle

Duty cycle refers to a transmission time limit regulated by law for
devices transmitting in the 868 MHz range. It is intended to ensure
smooth operation of devices operating in the 868 MHz range. The
maximum transmission time of each device is 1 % of an hour
(corresponding to 36 seconds / hour). Once the 1 % limit has been
reached it cannot transmit until the time limit of the duty cycle has
ended, so after one hour.

Included in delivery

1 x Wireless wall switch
1 x Button cell CR2450
1 x Installation kit (screws / dowels, adhesive pad)
1 x Quick start guide
1 x Instructions for use (digital, available for download)

Technical data

Product designation: APWT 868 01 IP44 3726
Item no.: 1294600
Radio frequency: 868.3 MHz
Frequency: 868.1 - 868.5 MHz
Max. transmitting power: < 20 mW
Duty cycle: < 1 % per h
Supply voltage: 1 x 3 V button cell CR2450
Power consumption: 30 mA max.
Battery life span: approx. 2 years (typically)
Ambient temperature: 0 °C to +35 °C
Protection type: IP44
Open area range: approx. 100 m
Dimensions (W x H x D): 79.3 x 79.3 x 17.4 mm
Weight: 54 g
Subject to technical changes without notice.
EN 13