Wireless flush-mount shutter actuator 868.3 MHz
Shutters "up" -> Device LED lights up green
Shutters "down" -> The device LED lights up red
Installation
Note: Check before installation whether the product is located
within the range of the Gateway.
CAUTION! DANGER OF ELECTRIC SHOCK!
Only install the product in a de-energised state!
Disconnect the electrical mains supply line by
switching off the circuit breakers connected to it or unscrewing
the fuse. Prevent this from being unintentionally re-started e.g.
with a warning sign.
Before installation, check the mains supply line with a suitable
measuring device to see that it is de-energised.
The mains voltage on site must correspond with the technical
data of the device (see "Technical data").
Check the power input of the consumer you intend to connect
to the device prior to installation. The travel time for up / down
is 120 seconds. Then, the motor is disconnected from the mains.
The maximum load is approx. 300 W.
The device must be operated in a suitable flush-mounted box or
surface mount box or assembled in another suitable casing to
guarantee the necessary electric shock protection.
Only operate the device when it is stationary.
L
N
PE
Connect the supply voltage cable to the screw terminals L and N
(N = neutral conductor, L = phase) and the supply voltage cable
"L" = phase of the shutter motor to the screw terminal C (see Fig.).
Connect the switched external conductors of the terminal A and
B to the shutter motor as follows:
Terminal A: Shutters "UP"
Terminal B: Shutters "DOWN".
Connect the neutral conductor of the motor to the neutral
conductor of the house installation.
12 EN
L
M
N
L
PE
Connect the "ground conductor PE" to the "ground conductor PE"
of the house installation.
Attach the wireless flush-mount shutter actuator to the flush-mounted
box using screws (hole spacing for mounting eyes = 60 mm).
Ensure during installation that the button on the housing front
is not covered and that it is not pressed by accident.
Download app / PC software BrematicPRO
The Brennenstuhl Home Automation Systems BrematicPRO is controlled
via the BrematicPRO app / PC software. The app can be downloaded
for free from the App Store and Google Play. The PC software is available
for download at www.brematic.com/en/service.
Please follow the on-screen instructions for download and installation.
For more information about the app and how to use it, please visit
www.brematic.com/en/service.
Pairing the wireless flush-mount shutter actuator
with the BrematicPRO Wireless Remote Control
The wireless flush-mount shutter actuator can be paired directly with
the BrematicPRO wireless remote control.
Press and hold the pair button for 3 seconds.
The LED will flash red.