Duty Cycle; Included In Delivery; Technical Data; Device Overview - brennenstuhl BrematicPRO UPWS 868 01 W1000 3726 Mode D'emploi

The range in buildings may vary greatly from open areas. In addition to
the transmission power and the reception characteristics of the receivers,
ambient conditions, e.g. humidity in addition to the structural conditions
on site, are important factors.
The range can be significantly reduced in part due to:
• wood, gypsum, concrete, reinforced concrete walls
• proximity to metal and conductive objects
• broadband interference, e.g. in residential areas (DECT phones,
mobiles, wireless headphones, wireless speakers, wireless weather
stations, baby monitors)
• proximity to electric motors, transformers, mains adapters, computers

Duty Cycle

Duty cycle refers to a transmission time limit regulated by law for devices
transmitting in the 868 MHz range. It is intended to ensure smooth
operation of devices operating in the 868 MHz range. The maximum
transmission time of each device is 1 % of an hour (corresponding to
36 seconds / hour). Once the 1 % limit has been reached it cannot transmit
until the time limit of the duty cycle has ended, so after one hour.

Included in delivery

1 x Wireless direct wire wall switch
1 x Quick start guide
1 x Instructions for use (digital, available for download)

Technical data

Product designation: UPWS 868 01 W1000 3726
Item no.: 1294700
Radio frequency: 868.3 MHz
Frequency: 868.1 - 868.5 MHz
Max. transmitting power: < 20 mW
Duty cycle: < 1 % per h
Supply voltage: 230 V / AC, 50 Hz
Max. switching capacity: 1000 W
Power input: 0.7 W
Ambient temperature: 0 °C to 35 °C
Protection type: IP20
Open area range: approx. 100 m
Dimensions (W x H x D): 79.3 x 79.3 x 45.3 mm
Weight: 83 g
Subject to technical changes without notice.
Wireless direct wire wall switch 868.3 MHz

Device overview

Front

Back

IN
L External conductor
connection L1 230 V phase
N Neutral conductor
connection N 230 V

Function

The wireless direct wire wall switch is part of the Brennenstuhl Home
Automation Systems BrematicPRO, controlled via app or the BrematicPRO
PC software. The wireless direct wire wall switch can be connected
and controlled directly with the BrematicPRO wireless remote control.
To use other software-based functions (i.e. control actions (tasks),
switch on / off devices) it must be linked with the Brennenstuhl Home
Automation Systems BrematicPRO via the BrematicPRO Gateway.

Installation

Note: Check before installation whether the product is located
within the range of the Gateway.
Toggle switch
Pair button
Device LED
Pair button
Cover frame
OUT
N Neutral conductor connection
N 230 V
L Switched external conductor
L1 230 V phase
EN 11