Adjusting the sound
Slight adjustments to the system can enhance
your sound enjoyment.
Adjusting the
subwoofer
(SA-VE705 and SA-VE702 only)
Operation panel on the subwoofer
1
Set MODE according to the program
source as follows:
Source
DVD, LD, video cassette
or other video source
MD, CD, cassette tape
or other audio source
2
Rotate LEVEL to adjust the volume.
Set the volume level to suit the program
source.
Notes
• Some amplifier functions for enhancing the sound
may cause distortion in the subwoofer. If such
distortion occurs, turn off those functions.
• To enjoy high-quality sound, do not turn the
subwoofer volume too high.
• To increase the bass sound from the subwoofer,
connect the system using "Hookup B" (see
page 5).
10
GB
LEVEL
MODE
MOVIE
!
ON/
STANDBY
MIN
MAX
LEVEL
Setting your amplifier
for Dolby Digital*
If your amplifier is connected internally or
externally with a Dolby Digital processor,
you should use the some setup menus in the
amplifier to specify the parameters of your
speaker system.
See the table below for the proper settings.
For details on the setting procedure, refer to
the manual that was provided with your
amplifier.
* To enjoy Dolby Digital, five speakers and one
subwoofer must be provided.
MUSIC
When "Hookup A" is used
(Speaker setup menu)
MODE
For
Front speakers
Center speaker
Rear speakers
MODE
Subwoofer
MOVIE
(Other setup menu)
Menu
MUSIC
LFE* MIX
BASS BOOST**
* Low Frequency Effect
**A function that reinforces the bass sound
When "Hookup B" is used
(Speaker setup menu)
For
Front speakers
Center speaker
Rear speakers
Subwoofer
(Other setup menu)
Menu
LFE MIX
BASS BOOST
Set to
SMALL
SMALL
SMALL
ON (or YES)
Set to
–10 dB
ON
Set to
LARGE
SMALL
SMALL
OFF (or NO)
Set to
–10 dB
ON