Disposing Of Packaging; Connecting The Appliance - V-ZUG Komfort 60i Notice D'installation

Disposing of packaging

Fig. 29
u Align the cabinet door to the height marked Z: loosen the
screws at the top and bottom of the door, then adjust the
door.
u Open the door to approx 45° so you can easily access the
screws under the door.
u Do not allow knobs and sealing lips
to make contact - important for func-
tion!
u Allow an air gap of 2 mm between
the unit door and the body of the
unit.
u Check the fit of the door and readjust if necessary.
u Tighten all screws.
Fig. 30 (10) with a no. 13 Allen key, making
u Tighten lock nuts
sure you counterhold the adjusting bolts
screwdriver.
Fig. 31
u Fit the top cover and click into place.
Check the following points to ensure the appliance is fitted
properly. Failure to do so may lead to icing, condensate forming
and malfunction:
w The door has to close properly
w The unit door must not butt against the unit body
10 Disposing of packaging
WARNING
Danger of suffocation due to packing material and plastic film!
u Do not allow children to play with packing material.
38
The packaging is made of recyclable materials:
- corrugated board/cardboard
expanded polystyrene parts
-
- polythene bags and sheets
- polypropylene straps
- nailed wooden frame with polyethylene panel*
u Take the packaging material to an official collecting point.

11 Connecting the appliance

NOTICE
Failure to connect properly
Damage to the electronics.
u Do not use a standalone inverter.
u Do not use an energy saving plug.
Failure to connect properly
Fire hazard.
u Do not use an extension cable.
u Do not use distributor blocks.
The type of current (alternating current) and voltage at the
installation site have to conform with the data on the type plate .
The socket must be properly earthed and fused. The tripping
current for the fuse must be between 10 A and 16 A.
The socket must be easily accessible so that the appliance can
be quickly disconnected from the supply in an emergency. It
must be outside the area of the rear of the appliance.
u Check the electrical connection.
u Plug in the power plug.
Fig. 30
Fig. 30 (13) with a
WARNING
* Depending on model and options