Installing The Appliance In The Recess; Installation - V-ZUG Komfort 60i Notice D'installation

Installing the appliance in the recess

Fig. 9
u Refit the door: Hang the door with its hinges and tighten the
screws.
Fig. 10
u Refit the closing dampers: Screw in the ball studs (1),
tighten the bracket (2) and hang the closing dampers in the
ball studs.
Fig. 11
u Check all screws and tighten if necessary.
u Refit the covers.
34
8 Installing the appliance in the
recess
WARNING
Fire hazard from short-circuiting!
u When pushing the appliance into the recess, take care not to
crush, jam or damage the mains power cable.
u Do not operate the appliance with a defective mains power
cable.
NOTICE
Risk of damaging the hinges!
If when being pushed the appliance is held by the door, the
hinges could be damaged.
u When pushing or otherwise moving the appliance, always
hold it by the main body.
For installation in the recess, the following accessories are
available from Customer Service:
Kit to limit the door opening angle to
90°
Risk of injury here! Follow the safety notes!
u Please take note of the information in the symbols key
during installation.

9 Installation

All the assembly components accompany the appliance.
Fig. 12
Ensure that the following tools are to hand:
Cordless Torx® screwdriver 15, 25
q
Spanner 13
q
Screwdriver Torx® 15
q
Flat-blade screwdriver 6
q
Allen key 8
q
Tape measure
q
Pencil
q
String
q
Spirit level
q
Pay attention that the socket is readily accessible.
Ventilation requirements
* Depending on model and options