Troubleshooting Guide - Bull NovaScale R460 Guide De L'utilisateur

Guide de l'utilisateur

Troubleshooting Guide

This section provides you a guide to identify a problem and locate its source.
The system power and any peripheral devices should be turned
off before connecting or disconnecting peripheral devices to or
from the system.
Otherwise, you could permanently damage the system or
peripheral devices.
1. Turn off the server and any peripheral devices. Disconnect all external
peripherals from the system, except for the keyboard and monitor. The
system´s power cord must be plugged into a grounded electrical outlet.
2. Make sure your keyboard and monitor are properly connected to the system.
Turn the monitor on, then adjust its brightness and contrast controls to suit
your preference (see your monitor´s documentation).
3. Turn the system on. If the power indicator does not light up, but the system
seems to be operating normally, the indicator may need replacement.
4. Monitor the power-on self test (POST) execution. Each time you turn on the
system, the POST checks the system board, memory, keyboard, and certain
peripheral devices.
5. Check the following during the POST:
■ (Error Message Line 1)
■ (Error Message Line 2)
■ Press F1 to continue,
■ F2 to enter Setup
■ You should note the error and press F2 to resume the boot-up process, or
6. Errors that prevent the boot process from continuing (fatal errors) are
communicated by a series of audible beeps. If this type of error occurs, record
the information and refer to
System Viewers
Monitor the occurrence of fault by NEC ESMPRO during the system operation.
Especially take note on whether any alert is reported to NEC ESMPRO Manager on the
management PC. Check whether any alert is reported on the Operation Window, Data
Viewer, or Alert Viewer of NEC ESMPRO Manager.
Avertissement !
F1 to enter Setup.
"Codes sonores" page 275
240
www.bull.com
.