Symbols On The Product; Customer Assistance; Product Liability - Husqvarna 122C Manuel D'utilisation

5. Throttle trigger
6. Stop switch
7. Throttle trigger lockout
8. Spark plug cap and spark plug
9. Starter rope handle
10. Fuel tank
11. Air filter cover
12. Air purge bulb
13. Choke control
14. Operator's manual
15. Combination wrench
16. Starter housing
17. Shaft coupling
18. Bevel gear
19. Grease filler cap, bevel gear
20. Drive disc

Symbols on the product

WARNING! This product is dangerous.
Injury or death can occur to the operator
or bystanders if the product is not used
carefully and correctly. To prevent injury
to the operator or bystanders, read and
obey all safety instructions in the
operator's manual.
Read the operator's manual carefully and
make sure that you understand the
instructions before use.
Use a protective helmet in locations where
objects can fall on you. Use approved
hearing protection. Use approved eye
protection.
Maximum speed of the output shaft.
The product agrees with the applicable
EC directives.
The product can cause objects to eject,
which can cause injury.
Keep a minimum of 15 m distance to
persons and animals during operation of
the product.
Use approved protective gloves.
941 - 007 - 24.08.2021
Use heavy-duty slip-resistant boots.
Only use flexible cutting wire. Do not use
metal cutting attachments.
Noise emissions to the environment
according to European Directive
2000/14/EC and New South Wales
legislation "Protection of the Environment
Operations (Noise Control) Regulation
2017". Noise emission data can be found
on the machine label and in the Technical
data chapter.
Air purge bulb.
Choke.
yyyywwxxxx
Note:
Other symbols/decals on the product refer to
certification requirements for other commercial areas.
Euro V Emissions
WARNING:
voids the EU type-approval of this product.

Customer assistance

For customer assistance, call: 1-800-487-5951 or visit
www.husqvarna.com.

Product liability

As referred to in the product liability laws, we are not
liable for damages that our product causes if:
• the product is incorrectly repaired.
• the product is repaired with parts that are not from
the manufacturer or not approved by the
manufacturer.
• the product has an accessory that is not from the
manufacturer or not approved by the manufacturer.
The rating plate shows the
serial number. yyyy is the
production year, ww is the
production week.
Tampering with the engine
3