Husqvarna 122C Manuel D'utilisation page 12

Note:
To see where the fuel tank is on your product,
Product overview on page 2 .
refer to
To examine before start
1. Make sure that the product has no missing,
damaged, loose or worn parts.
2. Make sure that nuts, screws and bolts are tightened.
3. Make sure that the trimmer head is not damaged.
4. Make sure that the air filter is not clogged.
5. Make sure that the safety devices on the product are
not defective.
6. Make sure that the product has no fuel leaks.
To start a cold engine
1. Push the air purge bulb 10 times.
2. Set the choke control in the choke position.
3. Hold the body of the product on the ground with your
left hand.
CAUTION:
product.
12
Do not step on the
4. Pull the starter rope handle slowly with your right
hand until you feel resistance. Then pull the starter
rope handle quickly and with force until the engine
starts or tries to start.
WARNING:
rope around your hand.
5. Set the choke control in the operation position.
6. If the engine starts, push the throttle trigger lightly
and let the engine run 60 seconds to become warm.
If the engine does not start, pull the starter rope
handle until the engine starts. Then push the throttle
trigger lightly and let the engine run 60 seconds to
become warm.
CAUTION:
rope to full extension and do not let go of
the starter rope handle. This can cause
damage to the product. Release the
starter rope slowly.
To start a warm engine
1. Push the air purge bulb 10 times.
2. Pull the starter rope until the engine starts.
To stop the product
• Push the stop switch to stop the engine.
Note:
The stop switch automatically goes back to its
initial position.
To trim the grass
1. Hold the trimmer head immediately above the
ground at an angle. Do not push the trimmer line into
the grass.
Do not twist the starter
Do not pull the starter
941 - 007 - 24.08.2021