Husqvarna 122C Manuel D'utilisation page 7

3. Make sure that the throttle trigger is locked at the
idle position when the throttle trigger lockout is
released.
4. Start the product and apply full throttle.
5. Release the throttle trigger and make sure that the
blades stop and stay stationary.
WARNING:
when the throttle trigger is in the idle
position, then the carburetor idle speed
must be adjusted. Refer to
idle speed on page 14 .
To do a check of the stop switch
1. Start the engine.
2. Move the stop switch to the stop position and make
sure that the engine stops.
To do a check of the cutting attachment guard
The cutting attachment guard stops objects that ejects in
the direction of the operator. It also prevents injuries that
occur if you touch the cutting attachment.
1. Stop the engine.
2. Do a visual check for damages, for example cracks.
941 - 007 - 24.08.2021
3. Replace the cutting attachment guard if it is
Muffler
•
•
•
•
•
If the blades move
Cutting attachment
To adjust the
•
•
•
Fuel safety
•
•
•
•
•
•
•
damaged.
Do not use an engine with a damaged muffler. A
damaged muffler increases the noise level and the
risk of fire. Keep a fire extinguisher near.
Examine regularly that the muffler is attached to the
product.
Do not touch the engine or the muffler when then
engine is on. Do not touch the engine or the muffler
for a while after the engine stops. Hot surfaces can
cause injuries.
A hot muffler can cause a fire. Be careful, if you use
the product near flammable liquids or fumes.
Do not touch the parts in the muffler, if the muffler is
damaged. The parts can contain some carcinogenic
chemicals.
WARNING:
Read the warning
instructions that follow before you use the
product.
Do the regular maintenance. Let an approved
service center regularly examine the cutting
attachment to do adjustments or repairs.
• The performance of the cutting attachment
increases.
• The life of the cutting attachment increases.
• The risk of accidents decreases.
Only use an approved cutting attachment guard.
Accessories on page 19 .
Refer to
Do not use a damaged cutting attachment.
WARNING:
Read the warning
instructions that follow before you use the
product.
Do not mix the fuel indoor or near a heat source.
Do not start the product if there is fuel or engine oil
on the product. Remove the unwanted fuel/oil and let
the product dry. Remove unwanted fuel from the
product.
If you spill fuel on your clothing, change clothing
immediately.
Do not get fuel on your body, it can cause injury. If
you get fuel on your body, use a soap and water to
remove the fuel.
Do not start the engine if you spill oil or fuel on the
product or on your body.
Do not start the product if the engine has a leak.
Examine the engine for leaks regularly.
Be careful with fuel. Fuel is flammable and the fumes
are explosive and can cause injuries or death.
7