Connecting The Power Supply - Westfalia 314 289 391 101 Instructions De Montage

Connecting the power supply

Note
If there is a suitable constant plus connector available in the luggage trunk (e.g. a 12 V power
socket, battery), this connector can be used.
Note
Ensure sufficient strain relief and correct installation of the fuse holder.
21. Connect the 2x1-pin plug to the matching counterpart of the vehicle's cable harness on the
left vehicle side (Fig. 1/4).
Remove the plus power supply from the luggage trunk socket, cut the red cable, connect the
Y-connector and connect it to the fuse holder.
Special information concerning vehicles with parking distance control (PDC)
On vehicles with PDC it is possible to deactivate the PDC for trailer operation. The PDC control
unit (Fig. 1/8) is located behind the right-hand covering of the luggage trunk.
22. Lay the brown/white cable of the trailer module connector (Fig. 1/8) to the PDC control unit
(Fig. 1/8) and connect it.
23. If the control line is not used, insulate and secure the cable end.
Checking correct operation
24. Reconnect the ground of the vehicle's battery.
25. Check the trailer function with the help of a suitable test instrument (with load resistors) or
with the help of a trailer.
26. Secure all cables using cable ties.
27. Refit any parts removed for installation.
18 314 289 391 101 31/04
Installation instructions:
Electrical system for towing hitch
Opel Meriva