Installation; General Instructions; Place Of Installation - Ferroli ECONCEPT 35 C Instructions D'utilisation

Masquer les pouces Voir aussi pour ECONCEPT 35 C:

Table des Matières

Les langues disponibles

2. Installation

BOILER INSTALLATION MUST ONLY BE PERFORMED BY QUALIFIED PERSONNEL, IN ACCORDANCE WITH

ALL THE INSTRUCTIONS GIVEN IN THIS TECHNICAL MANUAL, THE PROVISIONS OF CURRENT LAW, THE PRE-

SCRIPTIONS OF NATIONAL STANDARDS AND LOCAL REGULATIONS AND THE RULES OF PROPER WORK-

MANSHIP

The unit's combustion circuit is sealed with respect to the place of installation, therefore the appliance can be installed

in any room. Nevertheless, the place of installation must be adequately ventilated to prevent the creation of dangerous

conditions in case of even small gas leaks. This safety standard is laid down by EEC Directive 90/396 for all gas appli-

ances, including those with sealed chamber.

Therefore the place of installation must be free of dust, flammable materials or objects, or corrosive gases. The room

must be dry and not subject to freezing.

The boiler is arranged for wall-mounting and is equipped standard with a hooking bracket and a metal template for mark-

ing the drilling points on the wall. Wall fixing must ensure a stable and effective support for the generator.

•

Assemble the template (details 2 and 3 fig. 5) with the hooking bracket (detail 1 fig. 5).

•

Place the assembled template on the wall. Using a spirit level, check that the bottom bracket is perfectly horizontal.

•

Temporarily fix the template to the wall with screws or nails in the holes "4".

•

Mark the fixing points "A", where the hooking bracket "1" will be fixed with anchor screws. Mark the water and gas

connection points "B" then remove the parts "2" and "3" from the template. Fix the bracket "1" to the wall and hook

the boiler on it.

If the unit is enclosed inside cabinets or installed next to them, adequate space for removing the casing and

for normal maintenance operations must be ensured.

fig. 5 - Fitting the metal template

cod. 3540F320 - 02/2007 (Rev. 00)

ECONCEPT 35 C

Table des Matières

Table des Matières