Dometic Mini Heki Plus Instructions De Montage Et De Service page 16

Installing Mini Heki Plus
See fig. 6
➤ Clean the roof opening in the mounting area.
See fig. 7
NOTICE!
A
Observe the instructions of the sealant manufacturer.
➤ Seal the mounting frame with a flexible non-hardening sealing compound
(e.g. Sika - Lastomer-710).
See fig. 8
➤ Observe the direction of travel when installing.
➤ Place the outer frame in the middle of the roof opening.
See fig. 9
➤ Install the mounting frame.
➤ Tighten the screws 10 minutes after installation.
See fig. 0
➤ Install the fastening clips on the inner frame at the specified distances.
See fig. a
➤ Fit the inner frame into the mounting frame.
See fig. b
➤ Push the inner frame onto the mounting frame.
➤ After installing, check the roof light works properly.
➤ Remove the protective film from the acrylic glass.
NOTE
I
If the protective film is exposed to sunlight for too long, it cannot be
taken off without leaving a residue.
➤ If necessary, enter the new vehicle height and weight in the vehicle
documents.
14
Mini Heki Plus
EN