Risk Of Burns; Risk Of Injury; Causes Of Damage; Risk Of Electric Shock - Gaggenau AF2 Serie Notice D'utilisation Et De Montage

When gas burners are in operation without
▯
any cookware placed on them, they can
build up a lot of heat. A ventilation appliance
installed above the cooker may become
damaged or catch fire. Only operate the gas
burners with cookware on them.
Risk of fire!
Operating several gas burners at the same
▯
time gives rise to a great deal of heat. The
ventilation appliance may become damaged
or catch fire. The ventilation appliance must
only be combined with gas burners that do
not exceed the maximum total output of 18
kW. If the total output exceeds 12 kW, the
local regulations regarding room ventilation,
room size and the combination of ventilation
appliances with recirculation or circulated
air mode must be observed.

Risk of burns!

The accessible parts become very hot when in
operation. Never touch hot parts. Keep children
at a safe distance.

Risk of injury!

Components inside the appliance may have
▯
sharp edges. Wear protective gloves.
Risk of injury!
Items placed on the appliance may fall down.
▯
Do not place any objects on the appliance.
Risk of injury!
The light emitted by LED lights is very
▯
dazzling, and can damage the eyes (risk
group 1). Do not look directly into the
switched on LED lights for longer than
100 seconds.

Risk of electric shock!

A defective appliance may cause electric
▯
shock. Never switch on a defective
appliance. Unplug the appliance from the
mains or switch off the circuit breaker in the
fuse box. Contact the after-sales service.
Risk of electric shock!
Incorrect repairs are dangerous. Repairs
▯
may only be carried out and damaged power
cables replaced by one of our trained after-
sales technicians. If the appliance is
defective, unplug the appliance from the
mains or switch off the circuit breaker in the
fuse box. Contact the after-sales service.
Risk of electric shock!
Do not use any high-pressure cleaners or
▯
steam cleaners, which can result in an
electric shock.
20

Causes of damage

Caution!
Risk of damage due to corrosion. Always switch on the
appliance while cooking to avoid condensation.
Condensate can produce corrosion damage.
Always replace faulty bulbs to prevent the remaining
bulbs from overloading.
Risk of damage due to ingress of humidity into the
electronic circuitry. Never clean operator controls with a
wet cloth.
Surface damage due to incorrect cleaning. Clean
stainless steel surfaces in the direction of the grain
only. Do not use any stainless steel cleaners for
operator controls.
Surface damage due to strong or abrasive cleaning
agents. Never use strong and abrasive cleaning agents.
Risk of damage from returning condensate. Install the
exhaust duct in such a way that it falls away from the
appliance slightly (1° slope).