Sony TA-VE810G Mode D'emploi page 45

Severe hum or noise is heard.
/ Check that the speakers and components are
connected securely.
/ Check that the connecting cords are away
from a transformer or motor, and at least 10
feet (3 meters) away from a TV set or
fluorescent light.
/ Place your TV away from the audio
components.
/ Make sure you connect an earth lead to the
aerial ground terminal.
/ The plugs and jacks are dirty. Wipe them
with a cloth slightly moistened with alcohol.
No sound is heard from the centre speaker.
/ Select a sound field using the centre speaker:
PRO LOGIC, MOVIE (except NIGHT
THEATER and MONO MOVIE) (see page 25).
/ Select the appropriate centre mode (see pages
18 and 19).
/ Adjust the speaker volume appropriately
(see page 19).
No sound or only a very low-level sound is heard from
the rear speakers.
/ Select a sound field other than ACOUSTIC.
/ Select the appropriate centre mode (see pages
18 and 19).
/ Adjust the speaker volume appropriately
(see page 19).
Surround effect cannot be obtained.
/ Turn on the sound field function.
/ Set DIRECT PASS to OFF.
/ Make sure you set the SPEAKERS selector
correctly (see page 8).
Additional Information
Others
IR codes of components cannot be registered.
/ When registering the IR code, be sure to
check the following:
• Point the remote at the IR sensor on the
amplifier from a distance of less than 1 inch
(3 cm).
• Hold down the button on the remote for
about 2 or 3 seconds until the "RECEIVING"
display switches to "RELEASE YOUR
REMOTE".
• Keep the remote pointed horizontally at the
IR sensor until the code is registered.
Recording cannot be made.
/ Check that the components are connected
correctly.
/ Select the playback component with the
remote or with the AUDIO FUNCTION or
VIDEO FUNCTION controls on the front
panel.
A component cannot be selected
/ Check the FUNCTION hookup setting of the
component (see page 41).
GB
45