Watching Tv Or Video Programmes - Sony TA-VE810G Mode D'emploi

To turn off the selected component
Click in the bottom left corner. To turn on the
component, follow steps 1 to 3.
To turn off all components
Press ALL OFF on the remote control.
To mute the sound
Click . The icon changes to
in the display on the front panel. To turn the sound back on,
click on the icon again.
To listen to decoded Dolby Digital (AC-3)
programme sources
Click FUNCTION, then click 5.1 INPUT.
The video signal from the LD/DVD VIDEO IN jack is
automatically paired with the audio signals from the 5.1
INPUT jacks. When set to this mode, the audio signals
bypass the amplifier's sound fields. To customize the
sound of the 5.1 INPUT, use the controls on your Dolby
Digital (AC-3) decoder.
To listen to the analog audio signals input to the LD/
DVD AUDIO (L and R) jacks, select LD/DVD from the
FUNCTION menu.
You can play video and audio components at the
same time
Play a video component you want, then play audio
component. Make sure the AUTO PLAY function is set
to off (see page 30).
Notes
• Components of the same type (e.g., Sony LD player) will
be controlled simultaneously by the on-screen controls.
• If a component does not respond, it may be because IR
codes from the IR emitter are not fully reaching the
component. In this case, connect the extra IR repeater
(supplied) and position it facing the component (see
"Infrared (IR) Repeater Hookups" on page 6). If the IR
repeater is already connected, change the position of the
IR repeater or programme source.
• When 5.1 INPUT is selected, sound fields cannot be
selected or edited.
Watching TV or Video
Programmes
Use the TV tuner built-in to the VCR to watch TV
programmes; otherwise, the on-screen display will
change to a TV programme when you switch channels.
Also, set the VCR's TV tuner to skip channels where
. "MUTING" appears
there is no broadcast so that an image is always
displayed on the TV screen; otherwise, the on-screen
display will be distorted.
Before you begin, make sure you have:
• Connected your TV and VCR to the amplifier (see
1
2
If the Auto Play function is set to on (page 30)
Be sure to click p to stop playback from the VCR before
clicking CH + or –.
To change the video input of a Sony VCR
Click SUB, then click INPUT.
To switch the screen size when using a wide TV monitor
Click
• For non-Sony TVs : You must register the IR code for the
Playback/Recording
pages 8 to 9).
Select the appropriate VCR component (e.g.,
VIDEO 2).
FUNCTION SOUND
VIDEO 1
VIDEO 2
VIDEO 3
L D / DVD
SATL
MACRO 1
Click CH + or – to select the channel you desire.
–
+ SUB
CH
0 ( ) p
repeatedly to select the screen size you desire.
wide TV mode button on your TV's remote (see pages 13
and 14).
SETUP
TAPE
DAT / MD
CD
TUNER
PHONO
MACRO 2
USER
REC
P
21
GB